Using the mesh tool in archicad

Then, we can just click OK. They are rather different heights because they automatically found their position, and in fact we can actually put in the tree right here in 3D. I can click, and you can see that it actually puts the trees.

Let me just undo that. So, that concludes the lesson on train modeling, except that I want to go back and show you how it works with the metric version. There are a couple of key differences, so let me just switch over a metric one. So, as you recall, and this would be a good review for people in the U. In this training example, it will be set for one meter, or that will give you the correct results as opposed to millimeters, and I say place. Again, I can just click somewhere to place it, and it comes out.

Now, its placement is sort of arbitrary in the sense that right now, the center is where it is rather than the corner. I will verify the distance. Turn it on or off if you like. I need to go back into that command here. I click on Site, and I need to adjust again the structural bearing, and then click Update.

Very important. Now, before I place the mesh, remember I have to go to the Options menu and go to Project Preferences, Levels or Levels in Project North, and you see that it says first and second reference level. It's going to ,, so 22, millimeters or in This is going to be at a height of 19, I need to show where the survey is. You can always drag the reference again. Just drag it as many times as you need to get it in the perfect position.

You notice that it actually has a cover fill, which we had seen when I added the patio slab, so what I need to do is actually turn that off. That will make it a lot easier to work with. So, basically, the rest of the exercise is exactly the same as what I was demonstrating.

We had to adjust the layer combination for the site layers in order to be able to see the walls for alignment of the survey, and the terrain model, the terrain mesh is actually on a layer called Site and Landscaping Terrain, and then when we go to the Object tool and put in the trees, then we will need to switch the layer from interior equipment, which it was last used for. Click the pop-up arrow to change the Reference level, if needed.

Note: The Bottom Elevation shows the current elevation of the Mesh bottom. Thus, this value serves as a calculation tool only, not a link. If you change the position of a Reference level, the Mesh will not change its position. Mesh Floor Plan and Section Panel. Show on Stories: Choose an option to define which stories will display the Mesh.

The Show on Stories: Custom Settings dialog box appears, where you can set separate story display options for the slab outline and its fill. Note: Fills can only be displayed on stories where the outline is also visible. For more information, see Show On Stories. Cut Surfaces: In this section, set the attributes displayed for cut surfaces both in Section and on the Floor Plan.

Instead of the polyline can be any area. In a typical setting, the magic wand creates a path with the minimum number of points in the new element see figure.

The video lessons are available for viewing any time in your web browser, and may be downloaded to your computer for offline access. I only wish these had been available when I first began using ArchiCAD — they would have saved me a lot of time and helped me avoid many long and frustrating nights trying to figure out the program from the manual.

Thank you Eric! I would recommend this course and Eric Bobrow to any user whether novice or veteran as it is the best reference going. Use this free currency converter to find out. Note that your credit card issuer may use a slightly different rate, so please consider this only as an estimate.

Watch these lessons in your web browser, or download to your computer for permanent reference. Lesson 6 Case Study: Additional Techniques for Drafting Property Lines Part 6 is a 33 minute case study showing how to work with property surveys that include multiple arc boundary lines.