Ctek 90 zafir manual

Ground is normally connected to the negative terminal. Charging a negatively grounded battery. Be careful not to connect the black cable in the vicinity of a fuel pipe or the battery. Charging a positively grounded battery. Connect the black wire to the negative pole of the battery and the red cable to the vehicle's chassis. Be careful not to connect the red cable in the vicinity of a fuel pipe or the battery. Connect the red wire to the positive pole of the battery and the black cable to the negative pole.

Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions.

Enter a new password. ZAFIR Never charge a damaged battery. Do not place the charger on the battery while charging. The electrical connection must fulfil the national heavy current requirements. If the charger had not gone over to maintenance charging within 3 days, this is an indication of a problem. Only mount the charger on a flat surface. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up! Restore password. Upload manual.

Upload from disk. Upload from URL. Connect the red wire to the positive pole of the battery and the black wire Begin Charging 1. Set the correct voltage for the battery by pushing the Mode Selector Button until the light for the correct voltage is lit see Battery Types and Settings 2. When you are sure the battery leads are correctly placed, connect the power cord to the power outlet to begin charging.

If the battery leads are wrongly connected, the pole-changing switch will ensure the battery and charger are not damaged. In which case start from the beginning again. The charging lamp fi3 will now indicate charging or the maintenance lamp M will indicate that the battery is fully charged.

If the voltage drops the charger sends a pulse to the battery. The length of the pulse depends on how much the voltage has dropped. The charger can be connected for months 4. If nothing happens: If the voltage indicator is lit but no other lamp is lit there could be a bad connection to the battery or chassis or the battery could be faulty.

Check the wall power outlet. If you experience problems: start with the sensitive connection between the battery clamps and the charger 5. Charging can be stopped at any time by disconnecting the supply cord or by setting the charger on Standby.

Always remove the power cord from the power outlet before disconnecting the battery leads from a battery in a vehicle. When you stop charging a battery in a vehicle, remove the cable from the chassis before removing the other cable 6.

Rinse immediately with water if acid comes into Dontact with skin or eyes. Not even the world's smartest battery charger can save a used battery!